From empty the transmission takes 6 US gallons. To find level if you have no dipstick, remove bottom screw on one of round side covers and add 5 gallons and then add a little bit more if necessary until the oil runs out of the stud hole. The level will be slightly down on the normal level but it can be a good thing as it will often prevent any oil running through the seals onto the brakes.When you add the oil, only add 2 gallons at a time and then leave it for 15 mins before you add any more or the level may get too high in the Transmission and it could run into the Clutch Housing if the seal is worn on the main drive shaft into the Transmission from the Clutch.you need to allow some time for it to settle as there is a baffle built into the housings to prevent oil surge when the tractor is working on hillsides or the oil would all run to one end. Use Multi-grade 10W/30 oil...John(UK)...firstname.lastname@example.org
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.