Posted by PackardV8 on October 30, 2012 at 08:32:09 from (205.188.116.19):
In Reply to: Timing sight hole posted by HillsOfTN on October 30, 2012 at 04:27:26:
I am currently in the same situation as HillsofTN. I have a TE20 with Z120 Cont engine. IT has NO timing hole in the block apron under the starter. BUT it DOES have flywheel timing marks identcal to my other tractor a TO20 with Z120 engine.
I need to research a little further on this but my plan is to NOT drill the block. Plan is to count starter ring gear teeth on the TO20 and then re-mark the TE20 flywheel. That way i can time with a timing lite by removing the lower sheet metal flywheel cover.
However all of this raises a question:
Can a TO20 Z120 flywheel withfactory timing marks on flywheel be placed on a TE20 Z120 engine. THen drill the TE20 block for a timing hole and have all of it line up just fine for timing????? As i understand the John(UK) explanation above the answer to that question is No???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.