Posted by Gearhead210 on October 22, 2012 at 10:55:42 from (184.108.40.206):
I recently replaced the steering column and cylinder seals on this 35, since the old leather ones started leaking after about 60 years. The I/T manual says to use a "type A" ATF fluid, I used "type F" since type A is non existent. The type F ATF specifically says it is ok to use for power steering, but the issue is that the oil is still running out the top of the steering column and into the rack/sector gearbox from the valve. I have had this apart and put another new set of seals in it, the shaft is not badly pitted or worn- running out of patience now. My question is, would that oil be the wrong type and breaking these seals down? I am getting sick of an oily tractor. Note: every time I top the reservoir off after it starts whining from being too low, the oil is "foamy". Any help would be greatly appreciated.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.