Posted by DON TX on October 09, 2012 at 18:05:41 from (76.196.6.124):
In Reply to: Re: Shock!!! posted by mwferg on October 09, 2012 at 13:59:24:
The replacement pans I've found say they fit TE or TO. The 's e x bolt' (had to get past the potty filter) on the existing cover looks to be oem. The stud from the engine is a little off kilter but I can straighten that when I replace the pan. That's the only thing I can figure is it's off far enuff that it leaked so he welded it. A simple tack weld would have done and it could be ground off and retacked when the oil change was done. At this point I'm guessing. They sure went to a lot of trouble to screw it up. It'll be interesting to see what I find when I change it. Btw, do I need to take the long rods on each side of the engine off to replace the pan? DON TX
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.