Posted by John M on February 26, 2014 at 06:14:42 from (68.115.194.228):
In Reply to: Farmall m posted by Little ky farmer on February 25, 2014 at 09:42:43:
Someone correct me if I am wrong, been sometme since Ive been in an M engine, the cam bearings have hole for oil, right, and if not installed right will peg the oil pressure? Also, if these holes are not in the right position, the head will not get oil? Like I said its been some time since Ive been into one, I cant really remember. BTW, my 41 M has pegged the gauge since it was rebuilt in the late 70s. My other 41 has like 80 hours on therebuild and almost pegs the gauge at idle, and Im using the 75lb gauge on it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.