Posted by Janicholson on January 31, 2013 at 18:34:37 from (220.127.116.11):
In Reply to: Re: Farmall H posted by dcfarmall on January 31, 2013 at 18:25:21:
The stroker crank had to be welded up on an eccentric, then ground round at a greater stroke. My best guess is the diameter might need to be checked with Plastigauge. With the pump serviced, the only things left are the relief valve in the pump, and the bearings in the lower end. Both require removal of the pan to assess. For new it is way low. Did you check the accuracy of the gauge? Jim
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.