MoMike said: (quoted from post at 06:30:11 12/31/12) My 300, yes the one in the shop re: earlier posts, has a motor without a dipstick, exhaust manifold doesn't match parts diagrams on line, so does it belong in a 300 or is it a Super H motor. Doesn't make much difference to me other than needing parts. As long as it does what I need it to do that's all that concerns me. Your opinion may differ.
Early F300 tractors didn't come with a dipstick. See if the block casting # above the oil filter end with R1. Parts diagrams on line may show the last manifold casting IH made that would replace a F300 manifold. If so its not the one that came on the tractor.
Looked at the online picture. Gas manifold pictured was used on F350 tractors starting at serial # 705 on up. It become the replacement for a F300 manifold. F300 started dipsticks at tractor serial # 9338 or engine serial # 9341.
This post was edited by D Slater at 08:18:23 12/31/12.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.