Posted by will K on December 04, 2012 at 16:57:26 from (220.127.116.11):
I have owned this BN since 1966. It has given me very few problems over the years, until two years ago. It had been running fine, but one morning it wouldn't start. I finally have time to try to get it running again. It has an electric start. so I charged the battery and it will turn over. I pulled a spark plug wire and put a spare plug on it and grounded it to the frame. When I ran the starter, the plug sparked a nice blue spark. There is gas to the carburetor, in fact after trying to start it for a few minutes, it dripped gas on the ground. The carburetor is hard to id. I can see schebel? on the mounting flange. I checked both needles they are clean. I set both at 1-1/4th turn out. Thats where I'm at. Any suggestions?
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.