Posted by tomtirediron on July 08, 2012 at 11:29:13 from (208.123.10.208):
In Reply to: IH TD6 posted by Al Barclay on July 08, 2012 at 10:56:39:
Hi Al, Don't know about pins and bushings, but for what it's worth quoted 1400/side for a set of new TD-7 rails that would supposedly fit my TD-6. If I recall you have to then drill out your existing pads to fit the bigger bolt size of the TD-7. Nothing like putting $2800 into a $2500 dollar machine and getting a $2500 dollar machine. They're a nice little dozer love the gas start for winter, worked the snot out of mine for last 17 years wish there was an affordable answer. Good luck, Tom B.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.