You got a TC machine,that machine was the last backhoe that JCB built on a tractor base,it was only built for a short run,I forget what the filter setup was on them but it would be normal for it to have a suction strainer to stop anything getting to the pump,that pump has been known to siphon oil in from the steering pump section into the shuttle,hence the oil in the shuttle would rise so make sure the suction side has no restrictions,if it drives good when it does have pressure that says the clutches and torque are good,have a look at your manual regarding the direction valve,the manual should also tell you about the oil level,that pump is a PIA to RR,secure the loader in the raised position as a lot of struggling has to be done should you have to remove the pump.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.