Crawlers & Dozers Discussion Board |
Re: John Deere 440 Crawler
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lee Bradley on September 19, 2000 at 11:13:56 from (140.178.33.124):
In Reply to: John Deere 440 Crawler posted by Stacy on September 15, 2000 at 06:54:09:
440s hood have flush covers in the hood to access the fuel, radaitor, hydraulic fillers. The 40s, 410s, 420s and 430s had fillers that came through the hood. The 440s also used a round pipe cross shaft between the track frames the earlier models used solid square shaft. The 440s have a single track adjuster and spring on top of the track frame and the earlier models used two adjusters and springs on the side of the track frames. Lee
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|