Posted by cwheat on October 27, 2012 at 10:18:27 from (220.127.116.11):
I just acquired a 350B gas burner with a manual adjust inside mount 6 way blade. Has anyone tried to add a tilt cylinder and use the aux. hydraulic circuit to power it. Have been looking and thinking that it would not take too much to make it a power tilt that would greatly increase the ease of operation. Looks like welding cylinder mounts to the blade and bracket that the wedges are located in and sizing a cylinder with the right stroke would work if the radius guide would not hang during the movement of the blade. Just thought someone else may have already tried to modify one.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.