Posted by Charlie on October 25, 2012 at 17:59:40 from (220.127.116.11):
I would be terribly grateful if anyone might have a moment to help me with either of the following two inquiries. I have a hydraulic motor, possibly an old one, identified on the nameplate as Haldex Hydraulics Corp., Rockford, Ill. It has two numbers: 040206 and then further below: 77101. I would love to know its specs and especially the size and type of the fitting that should screw into the threaded holes on the sides. Itís too small for ĹĒ NPT and too big for 3/8Ē NPT, and Iím not even sure itís NPT.
Second, the motor is mounted on a blower that was removed from some kind of machine. Iíve attached a picture of the blower-motor combination. Do you have any idea what the application for this kind of blower might have been. You can see the motor on the right side and a 4 inch air intake on the opposite side. I've been thinking of rigging it up on my Bobcat 610 to blow leaves and debris.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.