Lower link advice

Abbby · Aug 21, 2013

So my lower left link arm is leaking oil and both are kind of worn out. I am thinking about replacing just the left one but then think about while I have it apart replacing both. Right is dry as can be so kind of hate to create a problem. seems both are pretty worn out. Thoughts? What sealant would I use to make sure things are sealed up good? What is the best pin to buy? Hate to buy a cheap one. This is a working tractor.

DollarBill · Aug 22, 2013

Replace both of them if they are worn out - Sponsors should carry good quality parts.

I would use the #1 Permatex Form-A-Gasket.

Ken N Tx · Aug 22, 2013

(quoted from post at 04:35:33 08/22/13) Replace both of them if they are worn out - Sponsors should carry good quality parts.

I would use the #1 Permatex Form-A-Gasket.

Ditto replace both..

9N or 8N ?? There is a difference..8N is tapered and does not need sealant unless the hole is worn out.
.
.

Abbby · Aug 22, 2013

It is a 9N. Do I need to replace 9N562 and 9N563? Seems like just the pin. Do you reccomend the gasket only for the trumpet and sealer on the pin parts?

souNdguy · Aug 22, 2013

if both worn.. and ou are going in for 1 leaker.. replace both..

Jim.UT · Aug 24, 2013

I have some used ones. The link is to a pair I have
on ebay, but I have others on the shelf.
ebay listing

Abbby · Aug 24, 2013

So can the 9N pin only be replaced or must the small casting go with it? Is it one piece?

Abbby · Aug 27, 2013

Does the 2N and 9N only come as an assembly or can the pin be replaced?

R Geiger · Aug 27, 2013

Check the parts listing for it on this site. Only shows the pin and the gasket.

Lower link advice

Abbby

Member

DollarBill

Member

Ken N Tx

Member

Abbby

Member

souNdguy

Well-known Member

Jim.UT

Well-known Member

Abbby

Member

Abbby

Member

R Geiger

Well-known Member

Similar threads