(800) 853-2651
SHOP NOW

Adding a PTO to IH 3414 tractor

A

Anonymous-0

Well-known Member
I own a IH 3414 tractor with no PTO however the tractor does have a couple of cover plates one where the engagement lever should be and the other at the rear of the tractor where the PTO shaft should be. I have removed the lever cover (below the seat on right side of tractor) and I can see the inner PTO shaft. It appears that all I need to add is the clutch and the rear PTO shaft assembly.
Has anyone done this before? Where can I locate parts?
Can it be done without removing the lift cover?
Anything I should / should not do before tackling this job?
 
This tractor is a intregal framed loader tractor with a heavy duty front axle. It was the mechanical/drive train parts of a B414 British tractor & engine. It evolved from B414 to 424 then 444. The transmission was equipped with a torgue converter to enable the hydra-shuttle forward & reverse. I would guess that a 414 pto would work. If possible call a CNH dealer & get the parts dept to print you some pages about pto parts break-down for research. Get the same from Komatsu/Dresser/Hough parts and see if any match. 3414 was unique sold only by CE dealers.
 
You must log in or register to reply here.

Similar threads

P
856 pto driven gear removal
Replies
5
Views
174
Janicholson
Janicholson
E
IH 3414 Hydro Help
Replies
3
Views
407
Mike(NEOhio)
M
M
IH 454
Replies
4
Views
228
derwen1959
D
P
international 300 utility tractor pto seal
Replies
4
Views
298
D Slater
D
X
340 International Industrial PTO Problems
Replies
1
Views
194
Janicholson
Janicholson
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top