Throttle rod to Governor thread size for a 49' 8N

greywolf224 · Jul 22, 2013

Folks, I wont be able to check until this coming weekend but does anyone know what the thread size and pitch is for the Throttle to Governor rod that is screwed into end ball joint connectors. My current end connectors are seized in the open position and tend to pop off of the governor ball connector.

I can pick up some aftermarket Dorman end connectors and would rather not pay 35 plus shipping for a whole new rod.

It isn't about being cheap, its about being pennywise

boler76 · Jul 22, 2013

soak them in ATF and buy nothing

greywolf224 · Jul 22, 2013

Even better. Didn't think of that. Than you

Dell (WA) · Jul 22, 2013

wolfie........according to my MPC, the throttle snap-on clipies are 10-32 ........Dell

greywolf224 · Jul 22, 2013

(quoted from post at 15:21:03 07/22/13) wolfie........according to my MPC, the throttle snap-on clipies are 10-32 ........Dell

Well thank you much sir. I was swaying at 1/4-28. You saved me some cussing.

Throttle rod to Governor thread size for a 49' 8N

greywolf224

Member

boler76

Member

greywolf224

Member

Dell (WA)

Well-known Member

greywolf224

Member

Similar threads