(800) 853-2651
SHOP NOW

Super M PTO Engagement Lever

D

dpoc

Member
Hello,

I am working working on a Super M and had to remove the PTO shaft and rear housing. When reassembling I noticed that the rivet head on the PTO engagement lever is wore (see photo). I tried to get a replacement from the local IH dealer but they said it was no longer available. Does anyone know if anyone still sells these? Has anyone tried to repair on of these in the past? If so, how did you go about it and where did you get the parts from? Is this a common problem with these types of tractors? Or is there another issue that would have caused this?

Thanks!
a84872.jpg
 
It cannot "fall" off once installed. I would be sure to use a washer on the shaft that the actuator lever is attached to. just thick enough to keep the rivet from rubbing on the engagement collar groove.
Just clean up the tiny burrs and shim it out to not rub. Jim
 
I think you have plenty of rivet left there to hold the piece on with out worry.(Mine looked similar to it last time I had it out.)

Like Jim says,see if you might be able to shim it away SLIGHTLY from the collar it rides in.

If it EVER would come apart,(which I doubt)A hardened,oval head bolt could be substituted for that rivet.
 
You must log in or register to reply here.

Similar threads

B
550 front PTO lever
Replies
7
Views
1K
BrotherJoe
B
O
PTO Engagement Lever leaking on D14
Replies
13
Views
738
onetotaltoolman
O
M
Oliver Super 55 Diesel Cracked Head and PTO Clutch
Replies
17
Views
799
magnumpowers
M
John M
Mods for my M
Replies
17
Views
686
gene bender
G
W
Super MTA PTO Woes
Replies
6
Views
951
wadej223
W
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top