TAP FOR AUXILLARY HYDRAULICS 3000

ZANE · Oct 3, 2012

How can you tap into the hydraulics on a 3000 without the add on control valve where the adapter plate is located.
I know how to tap into the hydraulics on the Hundred series without the control valve by tapping and plugging the hole under the adapter palte and then drilling and tapping a hole in the adapter plate for the return line and using the test port for the pressure line. I've got that rigged on my 660. I need to do something like that on a 3000 three cylinder so I can operate a two spool valve on a FIL.

Thanks, Zane

TheOldHokie · Oct 4, 2012

(quoted from post at 22:13:55 10/03/12) How can you tap into the hydraulics on a 3000 without the add on control valve where the adapter plate is located.
I know how to tap into the hydraulics on the Hundred series without the control valve by tapping and plugging the hole under the adapter palte and then drilling and tapping a hole in the adapter plate for the return line and using the test port for the pressure line. I've got that rigged on my 660. I need to do something like that on a 3000 three cylinder so I can operate a two spool valve on a FIL.

Thanks, Zane

Install one of the aftermarket remote port manifolds under the block off plate - part number is HV-5902 and sold here for $88.84. The manifold has an OUT port to your loader valve and IN port back to the three point valve. If your remote valve has power beyond the manifold also has a RETURN port direct to the sump. If your remote valve is a plain open center valve without power beyond the RETURN port on the manifold is not used - simply plug it

TOH

ZANE · Oct 4, 2012

Thanks Old. I'll look into it and see if I can figure it out.

Zane

TAP FOR AUXILLARY HYDRAULICS 3000

ZANE

Well-known Member

TheOldHokie

Well-known Member

ZANE

Well-known Member

Similar threads