(800) 853-2651
SHOP NOW

rear hub

T

tumleweed

Member
hey guys, on my 49 8N... is the rear hub actually supposed to make contact with the bearing retainer.

...and on the front axle pivot pin,the ID of the hole in the axle is not as big as the OD of the bushings I see hear, the axle came from a 1951. did these axle have bushings when built? do I need to bore the axle to fit the bushing?
 
(quoted from post at 19:07:26 09/27/12) hey guys, on my 49 8N... is the rear hub actually supposed to make contact with the bearing retainer.

...and on the front axle pivot pin,the ID of the hole in the axle is not as big as the OD of the bushings I see hear, the axle came from a 1951. did these axle have bushings when built? do I need to bore the axle to fit the bushing?
Click to expand...

The front axle had a steel bushing right from the factory. Did you remove it?

TOH
 
No, all there is is the bearing retainer and it looks like the hub has been contacting the retainer. is there a replacement part number for the bushing?
 
I'm sorry my mind must have jumped time, I thought you were talking about the rear bearing retainer. I'll look a little better for the steel bushing at the pivot pin.
 
You must log in or register to reply here.

Similar threads

D
Early 8N oul seal and retainer question
Replies
2
Views
189
Dan
D
S
Lubing The 885's Front Axle Pivot Pin
Replies
3
Views
152
ScottNC
S
S
IH 404 Rear Hub Snap Ring Removal
Replies
8
Views
481
used red MN
U
S
Home Brewed Align Bore For Front Axle Bushing
Replies
11
Views
560
ScottNC
S
M
Pulling rear hubs 8N
Replies
2
Views
483
Hobo,NC
Hobo,NC
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top