9n hyd control valve

tom j · Sep 21, 2012

the control valve sepereted from the t handle--cotter pin came out?--all parts of control valve missing in bottom of pump--cotter pin-spring,control valve. The t handle still attached to the fork... Is it a problem for the missing parts to remain loose somewhere internally??

Plane Bart · Sep 21, 2012

No they will be fine keeping company with the old starter bending parts.
You could try fishing them out with one of those flexible magnets or reach down their and get your arm stuck in tractor like I did a few months ago trying to get the Clevis pin for the hydraulic linkage.
FYI if you do that coat your forearm with the mineral oil to get it unstuck LOL

HCooke · Sep 21, 2012

He is talking about the hydraulic chamber, not the bellhousing. I think I would drop the pump (remember to drain the oil and remove the PTO shaft. Then I would clean out the sump as well as retrieve the broken hardware Might be able to fish them out with a magnet if you don't want to drop the pump.

heybusdriver · Sep 21, 2012

Did you accomplish getting out your clevis pin? I dropped an almost new starter drive in my bell housing, when I try a magnet , it sticks to everything before it reaches the bottom. If it was an electromagnet it might work, I wouldn't try my arm though, how do you get to the mineral oil if your arm gets stuck?

Stan
2N with 8N motor 8N345567
8N 146710
8N 179555
8N 197904
8N 199000
8N 254079
8N 362039

Plane Bart · Sep 22, 2012

Used my other arm and yes I was in the hydraulic sump
Still laughing that I did it

9n hyd control valve

tom j

New User

Plane Bart

Member

HCooke

Well-known Member

heybusdriver

Member

Plane Bart

Member

Similar threads