newfarmer9
Member
How do you remove the front (vertical) pin on the power steering cylinders on a G1355? I have the rear (horizontal) pin removed, both hydraulic lines on each cylinder off, and the snap rings on the front (vertical) pins removed. The front pins need to go up to come out, however there is only a fraction of an inch of clearance between the top of the pins and the cast radiator mount.
I see there are large holes in the rad mount to the rear of the steering cylinders, however even with the tie rods off and the tires jacked off the ground I can't pivot the steering mechanism far enough back to push the pins up and out of the hole. Any help?
I see there are large holes in the rad mount to the rear of the steering cylinders, however even with the tie rods off and the tires jacked off the ground I can't pivot the steering mechanism far enough back to push the pins up and out of the hole. Any help?