I need help with a carburetor kit

Anonymous-0 · Apr 20, 2013

I am looking to get a carburetor kit for a DLTX 8 and I am looking for some advice as to where to get a good quality kit with good gaskets that won't leak. Some kits online say they fit an A but they aren't very specific about what model. Any help would be great. Thanks, Bryan.

Anonymous-0 · Apr 20, 2013

Thanks for your help. The carburetor is a DLTX 8 brass body off of an A. I will give popinjohn.com a try. Thanks again, Bryan.

Hayrack · Apr 20, 2013

Actually guys... I have had great luck soaking them clean. Use your normal carb cleaner first to get all the grease and grime off, then I soak them in a 50/50 solution of muratic acid and water. I have found that most of them are rusted shut and the acid will eat every bit of rust out and when you pull it out, it will look like a new piece of cast! Then, use baking soda and water mixed to neutralize the acid. Good luck!

Mark-Ia · Apr 21, 2013

Most of those kits fit all the DLTX carbs. Only difference is the gasket under the bowl nut for the #51 carb for a G. It is usually included.

I need help with a carburetor kit

Anonymous-0

Well-known Member

Anonymous-0

Well-known Member

Hayrack

Member

Mark-Ia

Well-known Member

Similar threads