Unstyled B steering bearing - Larry Baker??? or Anyone

Mark in WV · Oct 9, 2012

I have a 38 and 36 unstyled b. The '36 has only a bearing in the end cap that the steering shaft bears against. However, the 38 model has an end cap bearing and a bearing that rides against the steering worm adjusting nut (where the shaft exist the steering housing going toward the driver). This bearing is not shown in my manual. Motion industries couldnt match it. Anyone have a part # or source???

Greenday · Oct 9, 2012

JD part # JD7364R. I found a website that has them http://www.1tractorparts.com/Jdbearings.html
Hope this helps, Dave

Mark in WV · Oct 9, 2012

I am showing that is the # for the bearing on the cap end...I may contact them anyhow to see if they know of the other one. Thanks

Sam Vastano · Oct 9, 2012

The bearings are the same front & back. I have a new one from JD if you are interested.

Sam

Mark in WV · Oct 9, 2012

Thanks Sam....My local Motion industries has that one so I will try it from them....May get back with you tho if something comes up...Thanks

Earl-IL · Oct 9, 2012

JD7364R changes over to 5BA Timken. You might have to leave the R off JD7364R to get the bearing from Deere.

Larry Baker · Oct 9, 2012

Mark just look at all your friends.Thats the good of this site.I got the last set I got from them but have no record of the numbers..

Mark in WV · Oct 10, 2012

Gotta thank Sam and everyone....I didnt check the two against one another...Stupid I know. They are the same and I should have one today. I greatly appreciate the help....Mark

Unstyled B steering bearing - Larry Baker??? or Anyone

Mark in WV

Member

Greenday

Well-known Member

Mark in WV

Member

Sam Vastano

Member

Mark in WV

Member

Earl-IL

Well-known Member

Larry Baker

Member

Mark in WV

Member

Similar threads