4020 drawbar support

ridgelane

Member
On the newer model 4020 front drawbar support, right at the very front, there is a roll pin into the casting. Does that pin hold the bushing in place, or does it go thru the bushing and pin. How do you take that apart? It doesn't look like it can be driven right thru to the other side.

Thanks
 
The roll pin holds the bushing in position. The horizontal pin is driven into the trans case and held by friction. Drive the pin out and lower the drawbar support. The roll pin can then be driven through the bushing to remove. You will need a good solid punch to drive the pin out of the trans case.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top