Streator small hobby
New User
A previous post suggested I unhook ball joints on
cylinders. I did this and the cylinders stayed
extended.
I saw a post and picture about tubing from
distribution block to cylinders and followed.
Does anyone know the for sure routing, Like top
fitting to inside cylinder??
Also, where is the for sure placement of the
castle plungers and 2 ball bearings as you sit on the tractor??
Also, the ported fitting near the return
on block, is this solid and little ball bearing
captured in it???
Thank you
cylinders. I did this and the cylinders stayed
extended.
I saw a post and picture about tubing from
distribution block to cylinders and followed.
Does anyone know the for sure routing, Like top
fitting to inside cylinder??
Also, where is the for sure placement of the
castle plungers and 2 ball bearings as you sit on the tractor??
Also, the ported fitting near the return
on block, is this solid and little ball bearing
captured in it???
Thank you