hildebrand40
New User
This message is a reply to an archived post by LAA on February 04, 2011 at 05:38:41.
The original subject was "Re: Hesston Round Baler".
Hello I just bought an 856A. I have not had any luck with the net wrap system. When I engage it. it runs for maybe a second and the monitor says check mesh. I open up the back and the mesh is cut and hanging off the backside of the unit. I thought it was a problem with to much force being required to turn the roll but I put some graphite on the skids and adjusted the cradle. The only other thing I can think of is maybe the proximity sensor is bad. Does anyone have any ideas for me?
The original subject was "Re: Hesston Round Baler".
Hello I just bought an 856A. I have not had any luck with the net wrap system. When I engage it. it runs for maybe a second and the monitor says check mesh. I open up the back and the mesh is cut and hanging off the backside of the unit. I thought it was a problem with to much force being required to turn the roll but I put some graphite on the skids and adjusted the cradle. The only other thing I can think of is maybe the proximity sensor is bad. Does anyone have any ideas for me?