(800) 853-2651
SHOP NOW

case 311 belt pulley

T

Tristan in MN

Member
I have a 1956 311, it has a leak around the splined shaft coming out where the belt pully would be. a cover was made to keep stuff from wrapping around the shaft, i finally took the cover off today. There appears to be a seal around the shaft, I looked it up under CaseIH parts and all i could find is a smooth shaft with a tapered end where the belt pully attaches. Question: is this just a different design for the belt pully attachment and where can i find the seal for it? thanks
 
Stupid question, but have to checked the oil level in the reservoir to make sure you don't have too much oil in it? Not sure about the seal. If you can get a number off the seal, I'm sure Motion Industries or NAPA can probably match it up.
 
Not a stupid question at all, actually the oil level in the torgue tube is low because all the oil seeps out at this level, i will have to dig into it one of these days. I found a bearing and seal supplier that is about 40 miles from here, hopefully they can match up what i need. thanks for the input.
 
You must log in or register to reply here.

Similar threads

W
Case 1490 water pump pulley
Replies
4
Views
235
Wetherdad
W
Slow lane 49
350 utility belt change
Replies
6
Views
391
Slow lane 49
Slow lane 49
D
Oliver 440 Steering
Replies
3
Views
298
Gambles
Gambles
J
How to replace fan belt with front crankshaft driven pump ?
Replies
9
Views
539
Caryc
C
B
Wheel Horse Charger 12
Replies
5
Views
708
timcasbolt
timcasbolt
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top