(800) 853-2651
SHOP NOW

allis wd45

T

TomFGW

New User
I would like to put a allis 262 motor (the 262 is currently in a gleaner combine) into a wd45, I would like to know if i have to change the rails and will it bolt up to the 45 bell housing? I want to make a pulling tractor. THANKS TOM
 

It will fit the rails and the bell housing. You will have to change the front out from your old engine because the Gleaner governor is different. It is a basic and simple swap.
 
thank you for the info i only have the motor right now just missed a diesel with a blown motor but if i understand this 262 motor will bolt up to a wd45 gas bell housing only issue is with the front end
 
Kip is right, to put it into a Gas will be a challenge. Will be just as easy to put a V8 in it. But Allis uses adapter plates on their 6 cylinder engines, just like IH does. So you can put them into anything. But a WD 45 has a small bell housing and hence a small flywheel and clutch. A D 17 diesel would be a lot better, can put a 426 in them. Vic
 
The 262 will fit. If you have a diesel tractor to begin with it goes right in no problems if dont you have to move the radiator and grill out to the end of the frame like the diesels are and make a longer hood or find a diesel hood. As far as the governers im not sure enought to say for sure if they are like the 226 engines you have to change some things over from the 45 block.
 
You must log in or register to reply here.

Similar threads

D
ALLIS-CHALMERS AND BUDA 1953 TO 1960 ??
Replies
2
Views
361
P Heisey Harleysville,PA
P
flooder1997
allis chalmers wd45
2
Replies
29
Views
2K
flooder1997
flooder1997
flooder1997
allis wd45
Replies
0
Views
107
flooder1997
flooder1997
F
Ac wd45 stroker build
Replies
4
Views
649
DrAllis
D
WELDINGWIZARD
  • Question
WD45 trans/ rear end question
Replies
8
Views
540
WELDINGWIZARD
WELDINGWIZARD
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top