(800) 853-2651
SHOP NOW

ck-40rear axle removal

8

88-1175

Member
i have the outside flange off and the nut on the inside off.cant seem to be able to remove the axle to get the bull gear out,is the axle held in by something else too....
 
My manual says to loosen the bolts on the bearing cap and bump the wheel flange outward with a heavy bar. Then take the bolts out and continue bumping till the shaft comes out. The splines in the bull gear may be stuck, too.
 
Hey Phil,

Maybe you can explain this. On my E-4, one axle housing has the grease fitting up and the other is down. It looks like one was installed upside down with no place to bolt the foot plate. I've seen lots of them at shows and they are all that way. Did they originally come this way?

Mike
 
Hi Mike,

The SAME axle housing trumpet....TG-9426 (early 40-50 with fixed std. axle) is used on either side. This is the way Cockshutt built most of their tractors.....35-40-50-GA-540-550-560-570-570S

The "30" tractor does have DIFFERENT trumpets on each side.

Phil
 
Thanks, Phil

I could see that both trumpets were the same part. I always fiured somebody worked on it and put it back together wrong. It looks like it would fit either way. And that cutout at the trumpet end looks like it could be clearance for some sort of mounted equipment.
 
You must log in or register to reply here.

Similar threads

F
Question on 200 final drives
Replies
4
Views
397
Fritz Maurer
F
showcrop
901 front wheel bearing retainer
Replies
5
Views
163
John P.
John P.
C
Case 732 rear axle hub removal
Replies
7
Views
237
pcrh
P
R
Super C bull pinion gear retaining washers/bolts
Replies
12
Views
325
300guy
3
R
Super C Bull Pinion Gear Retaining Washer & Bolts
Replies
3
Views
145
RTNystrom
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top