1650 3 pt

rrman61 · Aug 25, 2012

Have not gotten a shop manual yet.I am about to change the o-ring and crush seal on the 3 pt cylnder while I have the hydraulic unit off of my 1650.There is a wide o-ring on the piston like part.The new o-ring is about half as thick as the old one.There is no crush ring in it now.Where does the crush seal go?

OLarry from MD · Aug 26, 2012

Normally there is a big oring an a backup washer to take up the extra space.

rrlund · Aug 26, 2012

That backup washer goes to the rear.

rrman61 · Aug 26, 2012

So they are both in the grooves on the piston?One behind the other?What is there now is a large o-ring about 1/8-1/4 thick.

rrlund · Aug 26, 2012

There were two different groove widths on most of those so if you don't have it apart yet,I think you'll need a serial number. But yes,they both go in the same groove.

1650 3 pt

rrman61

Well-known Member

OLarry from MD

Member

rrlund

Well-known Member

rrman61

Well-known Member

rrlund

Well-known Member

Similar threads