(800) 853-2651
SHOP NOW

sickle mower

A

Anonymous-0

Well-known Member
We just aquired a belly mounted sickle mower for a allis B, The holes in the back are quite large, so I was wondering if a bushing goes in there. This is a 6 ft cutting bar is there a model number for it. It has a hand lift.
 
Thank you, I appreciate your answer. The forum is such a wealth of information. I am not new to allis chalmers but not well versed in the sickle mower.
 
Originally there were two tapered cast spacers to level the drawbar mounting surface. Not sure they were necessary, but they came with the mower. Use washers as shims to get the drive belt tight. Leave the center brackets that bolt to the foot rest cross bar loose until you get the belt adjusted, then tighten. Good mower to use, horrible to put on&off, repair record was lousy. We kept the local welder busy with ours--I still have it.
 
I wish Allis had designed a trip for the bar if you hit something!

Mine cuts real good in 2nd unless the grass is thin and thick.
 
You must log in or register to reply here.

Similar threads

D
Rear mount sickle mower for Super C w/ mid mount belly mower
Replies
6
Views
412
gene bender
G
B
Farmall A Sickle Mower
Replies
4
Views
503
Boomerang1955
B
J
Want to buy a pull behind Sickle Bar Mower
2
Replies
27
Views
5K
JoeyPorkChops
J
T
John deere sickle mower
Replies
4
Views
574
ajhbike
A
T
27V MOWER
Replies
5
Views
345
steve_in_mo
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top