(800) 853-2651
SHOP NOW

Allis C front end

Z

Zachary Hoyt

Well-known Member
I just traded for a couple of Allis tractors, a C with a B front end on it and a B parts tractor. I would like to put the C back to a narrow front, the current setup is pretty ugly and rough. The C steering rod(the "chicken roost") was cut and welded to the B front end rod, so I think I need the C rod and the C front pedestal assembly. If anyone has a lead on those parts or know if there are other parts I also need I would be very thankful. I think that the front rims will swap over but I am not sure. I will get some pictures soon.
Zach
 
You do not need a lead you just need a way to pick them up. I have 1 maybe 2 C front ends laying around and had a guy looking for the C steering rod so I know I have it since he never got back to me on it. E-Mail is open as always
 
I am wondering what the rod behind the seat on the C is for, if it was part of the cultivator or something. I have never seen a Monroe seat with the spring pointing up like that, but it seems to be the way it was made from what I have found online. I am going to put the radiator from the B on the C since the C engine is ready to run and the B engine has a big hole in the block. Then I will part out the rest of the B.
Zach
a91333.jpg

a91334.jpg

a91335.jpg

a91336.jpg

a91337.jpg
 
THe bar behind the seat is called the rock shaft. It normally has two arms attached to it. Serves the same purpose as the lifting arms on a 3 point hitch. ON the Allis, you pin the plow, disc, blade under the transmission, and the two arms on the rock shaft "lift" the attachement when connected to a cylinder.
 
https://photos.yesterdaystractors.com/cgi-bin/gallery/gallery_pic.cgi?pic=http;//photos.yesterdaystractors.com/gallery/iphotos/i50493.jpg&firstrec=124&Parameter=allis&w=iphotos&cc=0
Untitled URL Link
 
You must log in or register to reply here.

Similar threads

R
Splitting Allis C
Replies
12
Views
647
Ted in NE-OH
T
O
Allis Chalmers 621 Rough terrain forklift opinions
Replies
4
Views
294
oldfarmall
O
P
Allis B swap a mag for a distributor
Replies
17
Views
809
teddy52food
T
J
Allis B Loader
Replies
6
Views
525
jCarroll
J
B
Agco allow 6690 compatible front end loaders
Replies
1
Views
152
Jim.ME
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top