wd45 plowing

Steven-Id

Member
I didn't want to hijack the thread below but I have a question. My FIL passed away and he had some ground that needs to be plowed and he had a 2 bottom snap coupler roll over plow. The question is what is the proper way to get the plow to roll over? I have never seen this thing used. The only plows that I have seen used had hydraulics to turn them. I need to clean up the plow shares {spelling} but there has to be a right way to turn it over. Thanks in advance.

Steven
 

Study it and you should be able to figure how it turns...
Get it cleaned up before you go out or you will not do a good job..
I use a 4 1/2" Angle-Grinder with a thin Cut-Off Disc on it, held at a low angle..about 30 Degrees..
It will take all the rust off and NOT scratch the steel..
It won't even take the black oxide off, under the rust..!
Leaves a very good plowing surface..
Wear a Mask and safety glasses..

Ron..
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top