MF 20 Ind wiring

Samuels68

Member
Hello all--
I recently acquired my grandfathers 20 industrial loader and am looking to get it running again.
At this stage, the main problem appears to be electrical. Would anyone have a wiring schematic for this tractor, or know where I could get one?
Also while I am asking questions, does anyone have any tips, tricks, or advice about these tractors?
Hope everyone had a Merry Christmas and thanks in advance!
 
Would I be safe then, in using a wiring diagram for a 135 with a Perkins gas engine? I think that may be easier to come by, and more readily available.
 
I do have a schematic book which includes that
model. But I don"t send to the site, but poss if
you email me I can send, or send in mail. Do you
not have an owners manual-it should be in there.
Chuck
 
Chuck,
Thanks for replying. Unfortunately, I don't have an owners manual for this machine. I have looked a little bit online for reprint manuals, but was unsure if I was getting the exact one for the Industrial 20 not a TO-20, etc. They were a little pricey and I wanted to be sure before I ordered them. If you wanted to email the appropriate diagrams, I would appreciate it greatly, or if you prefer to mail them, email me at [email protected] and I will give you my home address. Thanks so much!

Jess
 
Hello,

Im sorry to jump in on this thread like this, but Im needing a little help. I just got an
Massey Ferguson 40 industrial and I am needing
to rewire it. I saw that chuck41 said that he
has some wireing diagrams. If you have it I
would like to get a copy of it if possible.

Thanks
 
Dasmason,

Chuck41 had a wiring diagram for me, and it was exactly what I needed, but as I got deepeer in to things, the factory wiring was so deteriorated that I ended up gutting and rewiring everything, using a rebuilt 1 wire alternator and eliminating the voltage regulator. It was actually simplere and took less time than the troubleshooting I did prior to that point. I don't know what your level of electrical knowledge is, or exactly how the 40 is set up, but I may be able to scan my hand drawn diagram that I used on my 20 and email it to you.
If not Chuck41 will probably see this and reply, but if he doesn't, let me know and I'll email him, but I won't give out his email without his permission first. Good Luck!

Jess
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top