I bought a MF1045 4x4 Loader Tractor. I'm suspect in it's previous life it had a frame mounted backhoe that would normally require removal of the vertical and lower 3 point linkages. Now just a loader tractor with 3 point hitch, the hitch lower link drawbars don't seem to have enough lift. When my Yorke Brand yorke rake is on the tractor & properly leveled using the top link, the rake barely rises 6 inches off the ground/the stroke of the lift is maxed out. I'm suspect after the backhoe was pulled and vertical lift links and bottom draw links were put on to make it again a functioning Ag tractor with 3 point hitch the original parts were not used. My first thought is the vertical lift links. They are 24 Inches center pin to center pin. Anybody out there have a 1045 or similar that could tell me the proper length of the vertical links and maybe even the center to center holes on the bottom/draw links?
- Thread starter Duetz Fan
- Start date
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy