Montgomery Wards 16 h.p. garden tractor tiller attachments.

I need to find someone that has the attachments for making my tiller workable. I recently acquired the tractor and tiller. The tiller Model # is Gil 331 163 A and the Serial # is 63558 44445. The tractor Model # is Gil 33181 A and the Serial # is 6037 A1 216. I would like to know if I can use a hydraulic set-up for it and does anyone have one? My phone # is 816-228-1239.
Thank you,
V. Wayne Pruiett
 
I think it would involve too much work to install hydraulics and expense. I have an older Wards tractor with hydrostatic drive and hydraulic lift. I replaced the hydrauilc cylinder probably 30 years ago and it was a pain
since you don't have much room to work. The cylinder is connected to a bell-crank to give it a mechanical advantage when lifting implements. Hal
2ynnjoy.jpg
 
Hal,
I appreciate your feedback on the hydraulic system. My real concern is getting the attachments to be able to use the tiller. If you or anyone out there knows where I might be able to get the right pieces please let me know. Again Sir I appreciate your response.

V.Wayne Pruiett
 
My 33095 tiller manual shows all the parts for installing the tiller for my tractor so your manual should show that. Hal
 
Here's the parts on my tiller. My tractor has a driveshaft and that takes up even more room in that area. Hal
sd1pvn.jpg
 
Hal,
I received your email and appreciate the picture of the tiller. Now I know what to look for. Again thank you. In case someone knows where I can find these parts my phone is 816-228-1239.

V.Wayne Pruiett
 
(quoted from post at 17:00:21 08/27/10) I need to find someone that has the attachments for making my tiller workable. I recently acquired the tractor and tiller. The tiller Model # is Gil 331 163 A and the Serial # is 63558 44445. The tractor Model # is Gil 33181 A and the Serial # is 6037 A1 216. I would like to know if I can use a hydraulic set-up for it and does anyone have one? My phone # is 816-228-1239.
Thank you,
V. Wayne Pruiett


I thiink I have the tiller you show and 3 other implements But am trying to figure what kind of tractor I need to make them work. Julie 907-895-5009
 
I have just acquired two of these tractors. One is M/W, the other is Gilson. (both gilson) I also just purchased a tiller for either of them. It seems the shaft is about 6 inches too long. Any thoughts? Should I cut it? I should, but don't have the model numbers in front of me at the moment.
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top