REDPOCADOT
Member
any one out there know the sizes that 1/4'' steel comes in i need bigger than 4 x 8 and don't want to weld them together i am having a tank rolled 30'' round 90'' long thanks
- Thread starter REDPOCADOT
- Start date
60 acre hillside
Member
It may be a bit difficult to find a shop that can roll anything 90 inches long. The shop where you have it rolled will get it for you in any sixe and shear what you need. When i ran a shop I did not like to form customers naterials as the mark up was in the sale of the steel. If I ruined a piece in forming It was my loss.
Joe N E Texas
Member
What are you going to use the tank for?
Anonymous-0
Well-known Member
Yes. Check with steel suppliers or custom rolling shops in your area. Dave
glennster
Well-known Member
here is a link to steel warehouse, they can do cut to lenght from mill coils in any size you need. you can also contact any large tubing and pipe suppliers and buy a lenght of tubing 30inch od x 1/4 wall in any lenght also. check for any drops that will fit your application instead of having them cut from a full lenght. central steel and wire is a good choice, also marmaon keystone tubing and pipe. they are nationwide companys. if you need an odd alloy, google delta centrifugal corporation, they make chill spun castings in all types of alloys.
steel warehouse
steel warehouse
Anonymous-0
Well-known Member
Pipe could probably work but I'd bet it would be more expensive than rolling a shell and welding it. 90" isn't that wide. Lots of 8' and wider rolls out there. What are you building? Does it need hemispherical heads on the end(s)? A shop up here can roll up to 11" thick plate heated to 1600 deg. or 7" thick plate cold. Dave
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy