(800) 853-2651
SHOP NOW

CIH 1640 final drive needed

M

msb

Well-known Member
A friend needs to find a used final drive for a 1640. Has tried several yards in and near central In. Any help would be greatly appreciated.A rebuilt one is nearly $600. Thanks, bob
 
I paid 500 for a salvage one with no rebuild about 10 years ago.

Better grab that rebuilt.

Gary
 
I agree, $600 for a rebuilt is cheap as it gets.

I have had to pay $500-$1000 for used with no rebuild.

I put the last design heavy axles shafts that are less prone to breaking in a 1480 last year. The new heavy shaft with seal and bearings goes for right at $2500.
 
axle tubes are the weak point on a 40 series, local shop used to put a tube in side the axle tube and weld it in, final drives have to be removed.
 
msb, I have one off of a 1440, depends on the year of his combine, but this one might work. Also is it a right or a left? I found out the hard way that on the 1440 series that it does make a difference, because there is no way to reverse them because of the fill and vent hole set-up. Also the gears from an 815 will fit in his housing, but the housings are different. You can catch me on here, I might be alittle slow getting back,but I will.
 
You must log in or register to reply here.

Similar threads

R
Looking at buying a 1640 made in Germany
Replies
6
Views
716
RusselLee
R
S
PLEASE HELP ME FIND
Replies
17
Views
1K
HFJ
H
T
terratrac gt 30 parts needed
Replies
1
Views
677
jean claude marleau
J
K
Case 580G gear box torque specs
Replies
4
Views
199
KurtPollack
K
B
Case 1816c loses power and dies when drive pumps are engaged.
Replies
7
Views
331
Fritz Maurer
F
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top