(800) 853-2651
SHOP NOW

Swinging drawbar hangar

T

Taildragger

Member
Purchased a Swinging Drawbar Hanger - Drawbar hanger. For 600, 8N, NAA, (Part No: NCA809A_)for my '49 8N. Mounting holes are slightly to far apart. Where are these after market parts manufactured or should I not ask? Probably, maybe, for sure China? I guess I can ream out the holes to oblong to sort of line up with the threaded holes on the tractor casting. Pretty light duty hangar but it may hold up for a while. Just sounding off my disgust with what appeared to maybe have been something that would fit! Especially since it came from Yesterday's Tractor Company. Disappointed but will modify it.
 
Talk to them and see what they will do, defective part so good chances they will make it right.
 
Mine was made in India, and I had the same problem as you. I just took a rotary file to the holes and elongated them just enough to get the bolts in. Hard going in steel that thick, so it took more than just a few minutes.
 
You must log in or register to reply here.

Similar threads

P
swinging drawbar interchange?
Replies
3
Views
622
Kirk-NJ
K
L
960 swinging drawbar
Replies
6
Views
757
Lynn Patrick
L
TheOldHokie
9N-803B
Replies
1
Views
1K
Greg 2N (TX)
G
M
Super M Plowing :Do I hook to the swinging drawbar?
2
Replies
24
Views
6K
Janicholson
Janicholson
A
swinging drawbar
Replies
3
Views
632
Anonymous-0
A
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top