I have a Farmall H And a question as well it pertains to timing and indicators that may or might not mean anything. On the crankcase cover there is a indicator pin or that is about 3/4" long and pointed. then on the flywheel ether are two mark one marking is a notch (V) and about a 1/4 turn of the crank the pulley has two notch's. If i align the pointer and the single notch up is this close to TDC or is when the two notch's align straddle the pin, and if one or the other is this a start to getting the timing correct I realize that once TDC I pull the magneto rotate the gears clockwise until the rotor makes two clicks. Any one that can help or clarify would be appreciated
- Thread starter MN Jerry
- Start date
glennster
Well-known Member
like the other gents said, the double marks are for ignition timing. there is a single mark away from the other two. if you spin the motor around and line up the single mark with the timing pointer, it will line up the grease zerk on the flywheel with the access hole in the bottom of the bell housing so you and grease the clutch pilot bearing.
Anonymous-0
Well-known Member
Try a little "hair of the dog", Tom. It takes care of that early morning jumpiness.
Anonymous-0
Well-known Member
See my note to Tom 43 below. Cheers.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy