I just recently got a Hesston 6400 Swather. It ran great for our second cutting but just as we were finsihing up the field we noticed the front idler pully was seazing up. This is one of the pullys that runs
the sickle bar. It should be a simple loosen the bolt and pull it off. What happend was the bearing and the bold have welded themselves together. This is not the easiest place to reach. Not much room to cut
bold either. I can replace the bolt and the bearing but need to get it off. Any suggestions?
the sickle bar. It should be a simple loosen the bolt and pull it off. What happend was the bearing and the bold have welded themselves together. This is not the easiest place to reach. Not much room to cut
bold either. I can replace the bolt and the bearing but need to get it off. Any suggestions?