(800) 853-2651
SHOP NOW

Ford /Dearborne hydraulic pump

jm.

jm.

Well-known Member
Location
Dover TN
Calling all you old Ford guys, neighbor brought me this hydraulic pump. It is pto powered from the
rear of a 8n ford that has what he call a Dearborne snow blade. Pump is leaking from the input
shaft end. Remove all the housing bolts but nothing loosened up. Am I going to have to press that
shaft thru the drive housing. I see no snap-ring or anything but I am hesitant to go to pressing
on this thing. Doubt that would be easy to replace.
cvphoto1444.jpg




cvphoto1445.jpg
 
Looks like a Cessna pump. There is still 4 cap screws it. Mounting flange weldment needs to be removed. There is numbers somewhere on flange proabaly on bottom.
 
Sure looks like a Cessna pump. There are 3 basic parts to the pump plus the base mount. The pump is held together by dowel pins. Try to remove the base first and then split the pump into the front and rear end plates and then the center section. Number one cause of leaking front seal is internal wear in the pump. Questions send e an e-mail
 
Thanks to both of you, I have the cap screws removed and as you say may just be the dowels holding it but so far no slack, guess we will work on it some more.
 
You must log in or register to reply here.

Similar threads

J
Ford 5000 injection pump problems
Replies
3
Views
517
Dieseltech
D
M
MM GB water pump issues
Replies
1
Views
247
MMDEL
M
T
1971 Ford 3500 Backhoe Electrical (also fuel pump)
Replies
3
Views
141
todintexas
T
C
Oliver 1650 Pump Noise
Replies
17
Views
676
ChevyK30
C
W
801 water pump seal replacement
Replies
1
Views
233
wore out
wore out
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top