(800) 853-2651
SHOP NOW

Ford 3400 brake shaft and bushing install

W

Willy A

New User
I have a Ford 3400 that needs to have the brake shaft bushings replaced. This tractor has A 730 loader on it.
1) Can I change the shaft and bushings without removing the loader? My tape measure says I dont need to remove the loader but since I have not done this repair before, I'm wondering if there is anything I'm not seeing?
2) It appears that there are bushings and/or seals available for replacement parts. What have all of you had success with using?
 
You will do better to ask this on the Ford
board. Click on the link below.
As for replacing the seals on your clutch
and brake cross shaft, it is a fairly
simple job. You want to remove both foot
boards and disconnect both brake linkages
and the clutch linkage from the pedals.
Attack the cross shaft from the right side
of the tractor. Remove the circlip then
the right pedal. Then remove the bolt from
the left pegal and pull it off. Remove the
woodruff key.
Now you can slide the shaft out from the
left side. The clutch pedal will come with
it.
Am going off of memory here and know there
are a couple of washers on the shaft so
pay attention where they go. I can't tell
you if this can be done with whe loader
on. Someone on the Ford board will likely
know.
Ford Board
 
You must log in or register to reply here.

Similar threads

Tom in TN
Replacing knotter shaft on a NH 273 baler
Replies
4
Views
240
Tom in TN
Tom in TN
A
Ford 861 throw out bearing cross shaft bushing
Replies
1
Views
189
shaun wallace
S
mikewood869
Ford 3400 power steering cylinder and lines
Replies
1
Views
280
Destroked 450
Destroked 450
M
Ford 555 leaking out of the side of the trans
Replies
3
Views
226
MiMisfit
M
D
Ford NAA New Front spindles with bushings
Replies
2
Views
154
Tim PloughNman Daley RIP
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top