(800) 853-2651
SHOP NOW

Ferguson TO-30 rear rim questions

T

tanner7212

Member
I am getting new tires and rims for my to-30 and what was on there (for probably 30 years) were 12.4x28 on 10" rims, which seemed to be fine. However, I know the "rule of thumb" is to have the rim just one size smaller than the tire. So do I need to get 11" rims or would 10" be okay? Would 10" be harder to mount? Thanks

Afterthought: I'm looking at getting the rims from either this site or All States Ag Parts. Any quality difference between the two? I can't figure out the shipping rates for all states but the prices seem to be comparable, I just don't know about the quality.
 
Don't about the quality, but running a 12.4 on a 10" rims is ok. The tread maybe not as flat with a 10" rim, but you probably won't notice any difference besides maybe a little bit more floatation 12.4's will give you. If you need more floatation get a pr of 12" rims, and run a 13.6 tire (that's what my 135 has).
 
12.4s replaced the old 11s,so you're only one size off from when the rims were built anyway.
 
You"re dealing with old and new size markings. Since you can go an inch wider or narrower than the rim, your 10 inch rim can be used with a 9, 10, or 11 inch tire...using old size markings. Your 12.4 is new size marking, same as the old 11 inch tire. No need to buy new rims.
 
You must log in or register to reply here.

Similar threads

M
Aftermarket rear rim problems
Replies
13
Views
800
mccormicksw4
M
A
135 rims on TO30?
Replies
2
Views
298
acaswell
A
T
Where to buy a rim for trailer?
Replies
14
Views
931
Tractorcedric
T
L
Re: JD 1020 Front Wheel Reversal
Replies
0
Views
260
Leroy
L
M
trailer tire tube mismatch
Replies
5
Views
449
Hemmjo
Hemmjo
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top