FtInn Farmer
Member
I have the head off am Allis Chalmers CA tractor. Three of the pistons are marked 8-2-R, and one is marked 1590-R. What do these numbers mean and is it ok to mix piston markings?
- Thread starter FtInn Farmer
- Start date
John M
Well-known Member
- Location
- Nunyafn business
Would that be Ft Inn, SC?
If they are the same weight or very close and all three are at the same height at the very top it would be fine. If they were not and didn't vibrate when running it would be fine also. It is of course always best to have every part matching. Sometimes when replacing just one cylinder people install what ever they can find close rather than put all matching new in because of available funds.
FtInn Farmer
Member
To: John M,
In response to your question about Fountain Inn SC, the answer is yes. I would like too figure out a way to contact you. The tractor is in Ownings
In response to your question about Fountain Inn SC, the answer is yes. I would like too figure out a way to contact you. The tractor is in Ownings
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy