Corrected drawing twice in wrong direction

David G · Jan 11, 2017

I am on my third drawing for the stepper motor bracket on CNC, corrected it once, and got twice as wrong.

RESLLS · Jan 11, 2017

I measured once and cut twice and it's still too short. I would have no idea how to do what you are doing. Have seen machines programmed, but I would be lost. I can run a manual lathe, computers, nope!

JMOR · Jan 11, 2017

(quoted from post at 18:26:04 01/11/17) I am on my third drawing for the stepper motor bracket on CNC, corrected it once, and got twice as wrong.

ut this post off 3 times & it is still too short! :evil:

David G · Jan 11, 2017

OK, got it right now.

I will mill the brackets this weekend to mount the stepper motors to the X and Y axis on the mill.

jeffcat · Jan 11, 2017

Hang in there David. Been down that road a couple of times. Hang in there!

Charlie M · Jan 11, 2017

My philosophy is any job worth doing is worth doing more than once. LOL

Bill in IL · Jan 11, 2017

At least it's only the drawing and not the third part ready to install but machined wrong.

David G · Jan 11, 2017

I like to make full size print if possible and lay out on matching part, caught a mistake more than ones.

4wdtom · Jan 12, 2017

Is that so you have both a right and left hand part...just in case?

Corrected drawing twice in wrong direction

David G

Well-known Member

RESLLS

Well-known Member

JMOR

Well-known Member

David G

Well-known Member

jeffcat

Well-known Member

Charlie M

Well-known Member

Bill in IL

Well-known Member

David G

Well-known Member

4wdtom

Well-known Member

Similar threads