(800) 853-2651
SHOP NOW

drag link ends

B

bbigman

Member
i have a ih 350u wide front tractor with power steering. my problem is i just had clyinder rebuilt fiquered that was off a 585 single clyinder
i am looking for ends the ones i have are center to end 4" thread is .795 16tpi pin is .675 at bottom and .795 at top can anyone help me fiquire what tractor
this is off of i have been unsuccessful so far please help THANK YOU
 
A 350U has steering draglinks going from the steering arms on the gear box to the radius arms on the spindle tops. They have ball joint type tierod ends on both ends, onr RH threaded one left hand threaded. What has this to do with a hydraulic cylinder? Jim
 
mine goes from wheel to wheel i ordered a set it didn't even have the right size end on them the cylinder was a reference . the rod is 39" long and 43" from center to center
this is why i am asking for help think my front end was changed
however it is power steering.even if someone knows something i can use that would be that link with the right size of .675 up to .757 on post of tie rod thank you
 
I would take them to NAPA or a Truck Supply specialty store to match them up. Sounds like 3/4X16 Left and right hand threads. Jim
 
You must log in or register to reply here.

Similar threads

4
is there 2 different rear ends for a 821?
Replies
4
Views
396
Hemmjo
Hemmjo
D
IH300U Drag Link
Replies
6
Views
272
Dave H (MI)
D
T
What do think, snow blade
Replies
3
Views
906
stevieb49829
stevieb49829
M
Tef20 wont select fwd gears
2
Replies
20
Views
502
Mark stevens
M
F
Dunham Lehr Inc/Farmhand 22 Loader Bucket Measurements
Replies
17
Views
607
ford4wd08
F
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top