I've got a bearing out on the combine. It's on a shaft about 8 inches behind the gas cap on the side of the combine. There's a pulley on it that runs the straw spreader that has to come off and it's on there but good. I don't know if the puller will budge it without putting a good deal of heat to it first.
I'm scared to death of the torch near that cap because of the fumes. I've thought about putting a piece of inner tube over the cap and neck and tightening up a hose clamp over it then wetting it down good,but I'd sooner scrap the combine and buy another one than blow myself up.
I'm scared to death of the torch near that cap because of the fumes. I've thought about putting a piece of inner tube over the cap and neck and tightening up a hose clamp over it then wetting it down good,but I'd sooner scrap the combine and buy another one than blow myself up.