So, you put a pto cross together with a new cross. A tedious affair....
But you find one side of the pto, the yoke, got squished while taking the old cross out.
So the two sides are maybe 3/8 inch too narrow on a bigger sized 540 assembly.
What is a good way to get the yoke spread back out again to proper width?
The press does a good job squishing them together if you aren't paying attention, but how do you re spread em?
My head isn't quite seeing the easy button tool on this task, I'm not sure heat is a good idea and don't want to start with the biggest hammer approach until I think this through....
Sigh, one of those days.
Paul
But you find one side of the pto, the yoke, got squished while taking the old cross out.
So the two sides are maybe 3/8 inch too narrow on a bigger sized 540 assembly.
What is a good way to get the yoke spread back out again to proper width?
The press does a good job squishing them together if you aren't paying attention, but how do you re spread em?
My head isn't quite seeing the easy button tool on this task, I'm not sure heat is a good idea and don't want to start with the biggest hammer approach until I think this through....
Sigh, one of those days.
Paul