1850 Oliver

BradyW · Jul 24, 2014

just picked up an old 1850 Oliver (gas) leaks oil from the 3 pnt arm linkage that meets the rear end housing. I know very little about ""the other good green tractors" my first one. im wondering how to replace that seal/bearing? From PTO in the back? or do i have to go under the seat and open up the back end? I have a shop manual but it does not show or share much. Any help-photo's, advise,direction would be greatly apprecated. Thanks Men. Brady

MoMike · Jul 24, 2014

Google Larry Harsin. He has a 'ask the Oliver mechanic' section on his web site. Full of information and very helpful. I got plenty of advice from him when I had issues with my 1650.

J.Wondergem · Jul 24, 2014

I replaced the seals in mine from the outside. Took the arms off and drilled a hole in the seal then run a screw in the hole to pull from.

1850 Oliver

BradyW

Member

MoMike

Member

J.Wondergem

Well-known Member

Similar threads